Email:sales@unitpcb.com Union Circuits Co.,Limited

Union Circuits Co.,Limited

Product Categories
Contact Us

Contact: Mr Kenly Lei

Sales Manager
Tel: +86 755 2970 9763
E-mail: kenly@unitpcb.com

Skype: kenly.lei


Contact: Ms Echo Yang

International Sales

Tel: +86 755 3350 1949 Ext. 810
E-mail: sales6@unitpcb.com
Skype: sales6@unitpcb.com


Contact: Ms Mary Huang
International Sales

Tel: +86 755 3350 1949 Ext. 812
E-mail: sales8@unitpcb.com
Skype: h-p88888

Endurance Properties Of Rigid PCB

     Because of the poor thermal capacity of the flexible PCB (compared with the rigid PCB), it is necessary to provide enough wire width. When some conductors carrying large current are facing each other or adjacent to each other, the extra wire width or spacing must be given when considering the problem of heat concentration. Shape: The rectangle should be preferred wherever possible, because it can save the base material better. There should be enough free margins near the edge, depending on the possible residual space of the substrate.Rigid PCB

    In the shape, the inner angle should look circular, and the pointed inner angle may cause the tearing of the plate. Smaller wire widths and spacing should be minimized as far as possible. If the geometrical space permits, the tightly arranged fine wires should be turned into wide wires. The wire terminated at the plating hole or the mounting hole of the component should be smoothly searched into the solder tray. As a general standard, any change from a straight line to an angle or a different line width must be as smooth as possible. The sharp angle causes the stress to concentrate naturally, causing the conductor to malfunction.Rigid PCB

    As a general standard, the bending radius should be designed as large as possible. The use of thinner laminates, such as 50μm copper foil instead of 125μm copper foil and wider wire, can improve the likelihood that it will withstand more cyclic bending. For a large number of bending cycles, single-sided flexible PCB usually shows better performance. Around the pad, there is a change from flexible material to rigid material. Rigid PCB

    The area is more susceptible to breakage of the conductor. Therefore, the pad should avoid appearing in areas prone to bending. The general shape of the pad should be like a teardrop, and the laminating must be able to cover the joint seam of the pad.Rigid PCB


Copyright © Union Circuits Co.,Limited All Rights Reserved.
QR Code