Email:sales@unitpcb.com Union Circuits Co.,Limited

Union Circuits Co.,Limited

Product Categories
Contact Us

Contact: Mr Kenly Lei

Sales Manager
Tel: +86 755 2970 9763
E-mail: kenly@unitpcb.com

Skype: kenly.lei


Contact: Ms Echo Yang

International Sales

Tel: +86 755 3350 1949 Ext. 810
E-mail: sales6@unitpcb.com
Skype: sales6@unitpcb.com


Contact: Ms Mary Huang
International Sales

Tel: +86 755 3350 1949 Ext. 812
E-mail: sales8@unitpcb.com
Skype: h-p88888

Metal Core PCB Line Device

     PCB core board: also known as printed circuit board, is the electronic components of the electrical connection provider. Its development has been 100 years of history; its design is mainly layout design; the main advantage of using the circuit board is to greatly reduce the wiring and assembly errors, improve the level of automation and production labor rate. According to the number of circuit board can be divided into single-sided, double-sided, four-tier, six-board and other multi-layer circuit boards. 1. Single panel: On the most basic PCB, the parts are concentrated on one side and the wires are concentrated on the other side. Because the wires only appear on one side, the PCB is called single-sided. Because there are many strict restrictions on the design of the single-sided board (because only one side, the wiring can not cross and must be around the path), so only the early circuit to use such a board. 2. Double panel: This circuit board has both sides of the wiring, but to use the two sides of the wire, must be between the two sides have the appropriate circuit connection Caixing. The "bridge" between such circuits is called via. Metal Core PCB  The guide hole is a small hole filled with metal on the PCB, which can be connected to both sides of the wire. Because the area of the double panel is twice as large as that of the single panel, the double panel solves the difficulty of interleaving in a single panel (which can pass through the guide hole to the other side), which is more suitable for use on more complex circuits than single panels. 3. Multilayer board: In order to increase the area can be wiring, multi-layer board with more single or double-sided wiring board. Metal Core PCB 

    With a double-sided inner layer, two single-sided for the outer layer or two double-sided for the inner layer, two single-sided for the outer printed circuit board, through the positioning system and insulation bonding materials alternately and conductive graphics According to the design requirements of the interconnection of the printed circuit board has become a four-story, six-layer printed circuit board, also known as multi-layer printed circuit board. The number of layers of the board does not represent a few layers of separate wiring layers. In special cases, the voids are added to control the thickness of the plates, which are usually even numbers and contain the outermost layers. Most of the motherboards are 4 to 8 layers of the structure, but the technical theory can be done nearly 100 layers of PCB board. Large supercomputers use quite a lot of motherboards, but because such computers can already be replaced with a lot of ordinary computer clusters, ultra-multi-layer board has been gradually not used. Because the PCB in the layers are closely combined, generally not easy to see the actual number, but if you carefully observe the motherboard, or can be seen.Metal Core PCB


Copyright © Union Circuits Co.,Limited All Rights Reserved.
QR Code